ANCEL S300 Lite Car EVAP Smoke Machine Diagnostic Vacuum Leak Detection Tester

Ancel S300 Lite supports multi-system testing, especially EVAP system EVAP System Test Intake System Test Exhaust Systems Test Crankcase system test Car Sealing Test Fuel Tank System Test Turbo System Test Various Pipe Fittings Test 2 kinds of modes: AIR model+Smoke mode Air mode :First, use the air mode to directly measure the leak, and judge whether there is a leak by the pressure gauge value. If it is less than 0.5bar, it will inevitably leak. If it reaches 0.8bar and above, the pipeline tightness is very good.Then there is no need to waste baby oil SMOKE MODE:After the air mode determines that there is a leak, use the smoke mode to find the leak. How to judge leakage- through the pressure gauge? NO Leak: When the value of the pressure gauge remains unchanged and the flow meter will read zero (ball at bottom of scale), it means that there is no leakage in the system. Small Leak: When the value of the pressure gauge drops and the ball in the flow meter slowly fall to the bottom of the scale, it indicates a small leak in the system. Massive Leak: When the value of the pressure gauge reaches zero and the flow meter ball never falls to the bottom of the scale, it indicates a large leak in the system. Overheat & Anti-frost Protection Overheat Protection When the temperature of the device exceeds 75℃, power protection will be intelligently activated to turn it off. Anti-frost Protection The device can also work normally at -20℃. How to use Ancel S300 Lite? 1. Fill 20ml baby oil to the detector for the first time. Open the engine cover, and hang the detector in the cover. 2. Disconnect the pipe that needs to be connected with detector. 3. Connect detector with DC12V battery, turn on the power switch, and the detector starts to work 4. In about 30 seconds, the pipe will be filled with smoke. Check the leak points. Please use head lamp if necessary.